What are the different levels of wastewater treatment?
There are several levels of wastewater treatment; these are primary, secondary and tertiary levels of treatment. Most municipal wastewater treatment facilities use primary and secondary levels of treatment, and some also use tertiary treatments.
How does wastewater treatment work?
In small communities, wastewater treatment facilities may consist of individual septic systems, simple collection systems that directly discharge effluent to surface waters, or municipal lagoons that are emptied annually. These facilities usually treat and disperse the waste as close as possible to its source, thus minimizing operational costs and maintenance requirements. The longer the waste can sit in a lagoon before being discharged, the less likely it will be to contaminate drinking water sources. Some communities store the waste in lagoons, but others release the waste directly into water sources.
How to reduce pressure on septic system?
Following some water conservation practices can greatly reduce pressure on your septic system. For more information about conserving water, see the fact sheet about Water Consumption. Here are a few things that you can do to care for your septic system: 1 Do not use your drain or toilet as a garbage disposal; avoid putting dental floss, diapers, coffee grounds and paper towel down the drain, as they can clog up your septic system. 2 Spread your loads of laundry out over the week. When too much water is added to the septic tank, it does not have time to treat wastes, and you could be flooding your drainfield with wastewater. 3 Plant grass on your drainfield, but keep trees and shrubs away from it, because roots can clog the system and cause damage. 4 Do not drive on your drainfield, because this can compact the soil and damage the septic system components.
Why is oxygen important in wastewater treatment?
The oxygen helps the bacteria to digest the pollutants faster. The water is then taken to settling tanks where the sludge again settles, leaving the water 90 to 95 percent free of pollutants. The picture below shows the settling tanks in the Winnipeg Wastewater Treatment Plant.
How is sludge treated?
The sludge that is removed from the settling tanks and the scum that is skimmed off the top during the primary steps are treated separately from the water. Anaerobic bacteria (anaerobic bacteria do not require oxygen) feed off of the sludge for 10 to 20 days at temperatures around 38 degrees Celsius. This process decreases the odour and organic matter of the sludge, and creates a highly combustible gas of methane and carbon dioxide, which can be used as fuel to heat the treatment plant. Finally, the sludge is sent to a centrifuge, like the one shown in the picture below. A centrifuge is a machine that spins very quickly, forcing the liquid to separate from the solid. The liquid can then be processed with the wastewater and the solid is used as fertilizer on fields.
Why is commercial wastewater not sent to public wastewater treatment plants?
Commercial and industrial waste is not sent directly to public wastewater treatment plants, because the public wastewater treatment system cannot effectively remove all of the contaminants. Wastewater from commercial and industrial processes is usually divided into the following four categories and dealt with accordingly:
Why do cities dump raw sewage?
Some cities choose to dump raw sewage into the oceans and rivers, because it is cheaper than effective treatment . A report published by Sierra Legal found that, of 22 Canadian cities, Victoria, Dawson City, Montreal, Saint John, Halifax and St. John’s dump some or all of their raw sewage directly into water bodies. While not all of the sewage is dumped directly into the oceans, these six cities produce 400 million litres of raw sewage each day! Montreal dumps around 3.6 billion litres of raw sewage into the St. Lawrence River each year, and Victoria is the only large Canadian city to dump all of its waste into the ocean without any attempt to improve the system. The city of Victoria dumps more than 34 billion litres of raw sewage into waterways each year, and still claims that their actions are not harming the environment! Halifax and St. John’s have plans to construct wastewater treatment facilities, but in the meantime, are still discharging 65.7 billion litres and 33 billion litres, respectively, of raw sewage into the Atlantic Ocean. For more information about water pollution, see the Water Pollution fact sheet, or the Operation Water Pollution lesson plans and resources.
What are the stages of wastewater treatment?
What Are the Three Stages of Wastewater Treatment? There are three main stages of the wastewater treatment process, aptly known as primary, secondary and tertiary water treatment. In some applications, more advanced treatment is required, known as quaternary water treatment.
Why is secondary wastewater treatment important?
Completing secondary wastewater treatment allows for safer release into the local environment, reducing common biodegradable contaminants down to safe levels.
What is biofiltration?
Biofiltration uses sand filters, contact filters or trickling filters to ensure that any additional sediment is removed from the wastewater.
Where is wastewater held?
During primary treatment, wastewater is temporarily held in a settling tank where heavier solids sink to the bottom while lighter solids float to the surface. Once settled, these materials are held back while the remaining liquid is discharged or moved through to the more rigorous secondary phase of wastewater treatment.
What is tertiary treatment?
In the case of water treated by municipalities, tertiary treatment also involves the removal of pathogens, which ensures that water is safe for drinking purposes.
What is the main objective of wastewater treatment?
The main objective of Wastewater Treatment is to separate solids from liquid then to treat both turning the solids into nonhazardous Bio-solids and water into non-threatening environmentally safe water to add back to the environment where it came from with the intention of using it again. 1. Primary Wastewater Treatment.
How is wastewater treated?
Primary treatment of wastewater involves sedimentation of solid waste within the water. This is done after filtering out larger contaminants within the water. Wastewater is passed through several tanks and filters that separate water from contaminants. The resulting “sludge” is then fed into a digester, in which further processing takes place. This primary batch of sludge contains nearly 50% of suspended solids within the wastewater. Again as you can see the principle of Wastewater treatment is to separate the solids from the liquid and the more the operation separates the solids from the liquid the cleaner the Wastewater becomes.
How many stages of wastewater treatment are there?
Wastewater treatment facilities involve natural, chemical, and physical processes that allow for development and growth. There are three different stages of wastewater treatment each one, working together removing organic and inorganic loadings that would pollute the receiving streams in our environment. What are the 3 Stages of Wastewater Treatment?
Why is aeration used in sewage treatment?
We will use this type to talk about. The secondary stage of treatment removes about 85 percent of the organic matter in sewage by making use of the bacteria that is naturally found in it. Increased oxygen encourages the growth of bacteria, which consume and breakdown the complex organic compounds.
Where is digested sludge sent?
The water is sent to the Headworks and the digested sludge is sent to Drying Beds or landfills. Sometimes the Gas made up of Methane is simply burned off. Digested sludge is passed through a dewatering step; the dried solids are disposed of, and the water is sent back to secondary treatment.
Where is the preliminary treatment located?
Stage 1.- Includes Preliminary Treatment is located at what is called the Headworks in the Primary Wastewater Treatment part of a plant. It involves the first couple of processes in a Conventional Wastewater Treatment Plant. Where inorganic material that won’t degrade in the Biological System is separated from the Wastewater. It’s a treatment process that is a vital part of the process and one that is often overlooked and the least pleasant part of the operation.
What is the most effective method of secondary treatment of wastewater?
Biofiltration- This method of secondary treatment of wastewater employs sand filters, contact filters, or trickling filters to ensure that additional sediment is removed from wastewater. Of the three filters, trickling filters may be the most effective for small-batch wastewater treatment.