How do I start a saltwater pool?
The start up of a saltwater pool is simple. If the salt water chlorinator is being installed on an existing pool, the water does not need to be drained. However, the water needs to be tested and properly balanced before the salt chlorinator is turned on. Note: Please refer to your owner's manual for specific ideal levels.
What should the salt level be in a well water?
The recommended level of salt in the water is 2700 to 3400 PPM, but ideally you will have it at 3200 PPM. Humans can taste salt when it is above about 3500 PPM, so if you can taste salt in the water it is a good indicator your salt levels may be too high.
Do salt water pools require less maintenance?
Salt water pools require less maintenance than conventional chlorine pools, but as you will discover below, there are still several vital steps that must be followed. Failure to do this can result not only in damage to your pool equipment, but it may also harm swimmers. The figures below are used for informational purposes only.
How do I connect my Intex saltwater system?
6:1210:46How To Setup An Intex Saltwater Pool Pump - YouTubeYouTubeStart of suggested clipEnd of suggested clipYou just screw that on it's pretty simple and then the nozzle inlet hose that comes with the saltMoreYou just screw that on it's pretty simple and then the nozzle inlet hose that comes with the salt water pump. Goes from the water outlet near the Electra load cell.
How do you set up a saltwater pump?
7:0116:30Intex 1600 gal/hr Sand Filter w/Saltwater System Setup InstructionsYouTubeStart of suggested clipEnd of suggested clipConnect the hoses to the sand filter saltwater. System making sure that the lower hose is connectedMoreConnect the hoses to the sand filter saltwater. System making sure that the lower hose is connected to the pump motor connect the other hose to the end of the electrolytic cell secure all connections.
How do you install a saltwater pool?
2:278:24How To Install Your Hayward Salt And Swim Chlorination System - YouTubeYouTubeStart of suggested clipEnd of suggested clipYou want to plan the location of both the cell and the control box the control box should beMoreYou want to plan the location of both the cell and the control box the control box should be installed within three feet of your GFCI outlet. Close enough for the power cord to reach. It.
How do you set up a saltwater above ground pool?
0:455:04How To: Start Up a Salt Water Pool - YouTubeYouTubeStart of suggested clipEnd of suggested clipThe alkalinity should be in the range of 80 to 120. Parts per million low or high alkalinity canMoreThe alkalinity should be in the range of 80 to 120. Parts per million low or high alkalinity can affect the pH level low alkalinity requires the addition of sodium bar carbonate.
How do you start a saltwater pool for the first time?
Spring into action: Tips for opening salt water poolsClear the cover. Debris should be removed with a leaf net and water should be pumped away before removing the pool cover. ... Clean and setup. ... Shock with chlorine. ... Use treatment products. ... Test and balance. ... Use pure salt. ... Ongoing maintenance.
Do you need a sand filter for a saltwater pool?
All saltwater pools need a Filter System to maintain crystal clear water. There are 3 types of filter systems you can choose from; Sand, Cartridge and D.E. Sand filters require specially graded sand to trap particles and debris.
Does it matter which way the salt cell is installed?
No it does not matter.
Which direction does a salt cell go?
0:203:30How to Replace your Hayward Aqua Rite Turbo Cell - YouTubeYouTubeStart of suggested clipEnd of suggested clipSo this is a T 15 cell. Right here and this is also T 15 cell. So this one's going to fit in and itMoreSo this is a T 15 cell. Right here and this is also T 15 cell. So this one's going to fit in and it goes you can put it in the same direction.
Can a salt cell be installed backwards?
The cell works the same regardless of which direction water flows. In fact my manual suggests that you reverse it each time it's removed for cleaning.
Do you need a special pump for saltwater pools?
Some Misconceptions About Salt Water Systems You need a special pump and filter to run a salt water pool. There is no such thing as a “salt water pump” or “salt water filter”; any pool pump or filter will do just fine.
What is needed for a saltwater pool system?
Besides normal and good water balance, all you need for a salt water pool is a chlorine generator and enough pool salt to raise the level to the salt system manufacturer's recommendation. You will still need to maintain good water balance on a salt water pool.
Do you need to shock a saltwater pool?
So, not only is shocking a saltwater pool okay, but it's actually important to your pool's health. Shocking is the process in which you overload your pool with chlorine (3-5 times the normal amount) to improve your pool's cleanliness and kill off organic matter.