Treatment FAQ

how to fully clean a rug doctor portable spot treatment

by Fermin Nader IV Published 3 years ago Updated 2 years ago

Your Rug Doctor Portable Spot Cleaner is ready to use right out of the box. Fill the Tank Fill the Clean Water Tank with hot water from the tap, filling to the line. Next, add Portable Machine and Upholstery Cleaner solution into the tank, filling to the soap line.

Part of a video titled Rug Doctor Portable Spot Cleaner Setting up and Cleaning
0:33
1:49
Turn the tank upright over the sink. Some water may drip from the cap as the tube empties any excessMoreTurn the tank upright over the sink. Some water may drip from the cap as the tube empties any excess water this is normal reinsert the tank by setting it straight down into the unit.

Full Answer

How to clean a Rug Doctor?

Nov 13, 2013 · A few tips that will help you get the most out the Rug Doctor. What to do before starting, testing color transfer on carpet, and how to use it on stairs. htt...

What is the best rug spot cleaner?

RUG DOCTOR PORTABLE SPOT CLEANER. 2. Always test color fastness before using on carpets and upholstery: A. Wet an inconspicuous area with a small amount of cleaner B. After 1-2 minutes, blot with a paper towel and check for color transfer 3. When cleaning, hold the brush upright, make sure the suction nozzle is in contact with

Where to rent a Rug Doctor?

Nov 21, 2013 · Explains Rug Doctor's special features as well as describes the set up process. http://www.rugdoctor.com/

Where can I find a Rug Doctor?

No assembly required. Your Rug Doctor Portable Spot Cleaner is ready to use right out of the box. Fill the Tank Fill the Clean Water Tank with hot water from the tap, filling to the line. Next, add Portable Machine and Upholstery Cleaner solution into the tank, filling to the soap line.

How do I clean my Rug Doctor Spot Cleaner?

0:151:32Rug Doctor Portable Spot Cleaner Cleaning your Machine - YouTubeYouTubeStart of suggested clipEnd of suggested clipKeep the inlet opening upward remove the wide opening lid and the float column from inside the tank.MoreKeep the inlet opening upward remove the wide opening lid and the float column from inside the tank. And set aside empty the dirty water into the sink and rinse the inside of the tank.

How do you use Rug Doctor portable detailer and spot cleaner?

0:271:29How To Use The New Pro Portable Spot Cleaner - YouTubeYouTubeStart of suggested clipEnd of suggested clipAdd one capful of the rug doctor cleaning. Solution to your clean water screw. The cap back onMoreAdd one capful of the rug doctor cleaning. Solution to your clean water screw. The cap back on tightly to ensure full suction power secure. The clean water tank on the pro portable spot cleaner.

How do you clean a Rug Doctor spray spout?

0:213:21Rug Doctor Portable Spot Cleaner Troubleshooting Guide - YouTubeYouTubeStart of suggested clipEnd of suggested clipMake sure you're pressing the spray trigger hold the spray trigger down for constant sprayingMoreMake sure you're pressing the spray trigger hold the spray trigger down for constant spraying release. And press again every 10 to 12 seconds to get a clean stream of water.

Why is my Rug Doctor spot cleaner not spraying water?

Make sure you're pressing the spray trigger down for consistent coverage. Check the water tank level and refill if it is low or empty. Make sure the water tank is fitted correctly.

What can I use to clean spots?

Pretreat it with a liquid laundry detergent, using an up-and-down motion with a soft brush to break up the stain. Rinse well. Sponge with white vinegar and rinse again. Repeat, treating the stain with liquid detergent, then with white vinegar until you've removed as much stain as possible.

Can I use Rug Doctor detergent by hand?

Great not just for carpets, the Pet Formula Carpet Detergent is also ideal for rugs, upholstery and mattresses when used with Rug Doctor's Hand Tool.

How do you empty unused water from a Rug Doctor?

0:071:29How to Clean a Rug Doctor Carpet Cleaning Machine - YouTubeYouTubeStart of suggested clipEnd of suggested clipThe white bucket. And tip the Machine forward and upside down unplug machine before cleaning. Do notMoreThe white bucket. And tip the Machine forward and upside down unplug machine before cleaning. Do not spray or mousse machine and water remove the filter by pushing the spring.

How do you reset a Rug Doctor?

0:241:23Rug Doctor machine will not start - troubleshooting video - YouTubeYouTubeStart of suggested clipEnd of suggested clipCheck your mains fuse box to see if it is tripped on the circuit. Then push the reset button on topMoreCheck your mains fuse box to see if it is tripped on the circuit. Then push the reset button on top of the machine if this button pops up there's a fault with the machine.

How to contact Rug Doctor for warranty?

To obtain Warranty assistance, please call 1-800-RUG DOCTOR (1-800-784-3628) , or email [email protected]. Rug Doctor will need the following information in order to assist you: your name, address and telephone number, product model and serial number, proof of purchase showing date and place of purchase.

How to clean a portable spot cleaner?

Fill the Clean Water Tank with hot water from the tap, filling to the line. Next, add Portable Machine and Upholstery Cleaner solution into the tank, filling to the soap line. Screw the cap back on and turn it over the sink, then firmly reinsert the Tank into the Portable Spot Cleaner. Then unwind the power cord, plug it into a grounded outlet, and you’re ready to begin. Prepping Your Portable Spot Cleaner

How to clean a stain with a sandpaper brush?

Using the Machine. Position the brush in front of the stain you want to clean. Squeeze the trigger, then turn on the motorized brush by pressing the power switch on top of the handle. Slowly move the brush over the stain, then release the trigger when you’re done .

How to clean a sanitizer?

Position the brush in front of the stain you want to clean. Squeeze the trigger, then turn on the motorized brush by pressing the power switch on top of the handle. Slowly move the brush over the stain, then release the trigger when you’re done . Any excess dampness can be cleaned up by making additional passes with the brush without squeezing the trigger. Leave the machine on for 15 seconds after cleaning to allow dirty water to collect completely into the Waste Water Tank.

Is Rug Doctor a warranty?

Rug Doctor® carpet cleaning machines have been manufactured, tested, and inspected in accordance with Rug Doctor’s high standards of quality. The Rug Doctor Portable Spot Cleaner (“Machine”) is backed by a two (2) year limited warranty (“Warranty”). Please consult your User’s Manual to see the full terms of your Warranty.

How to contact Rug Doctor for warranty?

To obtain Warranty assistance, please call 1-800-RUG DOCTOR (1-800-784-3628) , or email [email protected]. Rug Doctor will need the following information in order to assist you: your name, address and telephone number, product model and serial number, proof of purchase showing date and place of purchase.

Can you use Rug Doctor for rental?

For best operating efficiency and cleaning use of Rug Doctor products is recommended. Use of the Machine for rental voids the Warranty and is not permitted under Federal Law (see “UNAUTHORIZED USE” statement below).

How to get vacuum suction out of a vacuum cleaner?

Follow the vacuum hose set to where it connects to the back of the machine. Disconnect the black vacuum hose by pulling straight out. Place your fingers over the hole where the vacuum hose was removed. Turn the power switch to the on position and you should feel vacuum suction.

What to do if you don't feel suction on hand tool?

If you do not feel suction on the hand tool, first verify the dirty water tank is not full of water. When the dirty water tank is full, there is a float that will turn off the vacuum pressure not allowing more water to be extracted. Empty the dirty water tank if necessary.

How to check if a vacuum is suction?

To check for proper vacuum suction, first verify the area you are cleaning is getting wet. If the area is wet, then proceed to checking the vacuum system. With the machine powered on, place your hand along the vacuum nozzle on the hand tool. Use caution because the brush will be spinning.

How long does it take for a sandpaper brush to spin?

Troubleshooting. When you first turn the machine on, it may take up to three seconds for the brush to start spinning. If the brush does not start spinning after five seconds, turn the machine off and unplug from outlet. Check that there is nothing stopping the brush roll from rotating.

A B C D E F G H I J K L M N O P Q R S T U V W X Y Z 1 2 3 4 5 6 7 8 9