How do you mix Hi-Yield 38 Plus for fleas?
You would mix 1. 6 fl oz of Hi-Yield 38-Plus Insect Control - 38% Permethrin with 1 gallon of water to make a 0. 5% spray solution to treat active infestations only.
How do you mix a hi-yield 2,4-D Amine?
According to the Hi-Yield 2, 4-D Selective Weed Killer product label, in pastures and range land: Use 1 gallon in 15 gallons of water; or small areas, use 3 to 4 fluid ounces (6 to 8 Tablespoons) per 1,000 square feet; mix 1 to 3 gallons of water and apply uniformly over the area.
How do you mix Hi-Yield 38 for mosquitoes?
Mix 1.6 fluid oz. (3 1/4 Tablespoons) of this product per 1 gallon of spray solution to make a 0.5% spray emulsion. SPOT TREATMENT: Apply a 0.5% emulsion as a pin stream low-pressure spray or as a paint-on application with a paintbrush.
How do I apply triclopyr to my lawn?
Apply foliage sprays during warm weather, early spring through fall, when weeds are actively growing. Apply 1/2 to 1 quart of HI-YIELD Triclopyr Ester per acre in enough water to control broadleaf weeds actively growing in perennial bluegrass, perennial ryegrass, or tall fescue.
When Should I spray my 2,4-D amine on my lawn?
The best time to apply 2, 4-D weed killer on your lawn is when weeds are still young and starting to grow. This may be during spring, although some weeds germinate in fall and summer. Spray 2,4-D at least 6 weeks after newly seeding or sodding your lawns to prevent retarding the grass.
Does 2,4-D need a surfactant?
It's important to combine 2,4-D with a surfactant. Surfactants are compounds that cause herbicides to stick to plants and increase effectiveness.
How do you mix Hi-Yield?
1:573:53How to Mix the Ratio for Hi-Yield Killzall Super Concentrate Weed ...YouTubeStart of suggested clipEnd of suggested clipThe concentrate will mix with water from a garden hose at the rate of 1.5. Ounces per gallon screw aMoreThe concentrate will mix with water from a garden hose at the rate of 1.5. Ounces per gallon screw a garden hose onto the sprayer.
How do you mix Hi-yield insecticides?
Indoor/Outdoor Broad Use Insecticide (32 oz)Indoor ornamental plants, outdoor ornamental plants, trees & shrubs: One ounce in 4 gallons of water.Home lawns: 1/2 ounce in 3 gallons of water treats 1,000 sq. ... Vegetables & fruits: 1 to 3 oz to 4 gallons of water to cover 4,000 sq.More items...
How do you mix Hi-Yield insect control?
Yes, Hi-Yield Lawn, Garden, Pet and Livestock Insect Control can be applied on horses and dogs and is labeled to mix at a rate of 1 part concentrate in 19 parts water (6. 7 fluid ounces product per 1 gallon water). Apply a light mist ssufficient to wet the surface of the animal.
Should you use a surfactant with triclopyr?
It is recommended to add a non-ionic surfactant for best results but is not required per label instructions.
What is the mix ratio for triclopyr 4?
The mix rate for triclopyr is 3.2oz to 6.4oz per gallon. Triclopyr is more effective if mixed with a bark penetrent like methylated seed oil.
Can you plant after using triclopyr?
Triclopyr is a systemic herbicide that moves throughout the plant tissue and works by interfering with cell growth and division. Following treatment, plant growth will be abnormal and twisted, and then plants will die within two to three weeks after application. Plants will decompose over several weeks.