What is the difference between the DWS/SE and dwsw-8 ultraviolet disinfection lamps?
The DWS/SE series come with an ultraviolet lamp designed with one pin at each end. This type of lamp has a socket connected to each pin. The DWSW-8 model comes with a bi-pin connection at each end. A stainless steel threaded nipple with a brass compression nut and O-Ring is located at each end of the disinfection chamber.
How to contact Aqua treatment service?
AQUA TREATMENT SERVICE, INC. 194 HEMPT ROAD MECHANICSBURG, PA 17050 ph: (717) 697 - 4998 fax: (717) 697 - 5035 Series EPA PRODUCT REGISTRATION # 062333-PA-001 2 SAFETY INSTRUCTIONS WARNING - to guard against injury, basic safety precautions should be observed, including the following: 1. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. 2.
How often does the green LED flash on a DWS 15?
INSTALLATION & OPERATION MANUAL This manual covers installation, operation and maintenance requirements for DWS/SE/DWSW U.V. Disinfection Units. Models DWS-7, 15, and SE-7, 15, and DWSW-8, 15 (SE Units: During normal operation, the Green LED will flash every 5 - 10 seconds.)
Will this UV quartz sleeve work in my Aqua treatment service system?
This uv quartz sleeve is guaranteed to work in your Aqua Treatment Service (ATS) system. When you purchase from us, you are guaranteed a quality replacement part that is designed to keep your water safe. We support our products and will gladly assist you with any pre or post purchase questions.
How do you test a UV ballast?
0:411:42How to test a Fluorescent Ballast - YouTubeYouTubeStart of suggested clipEnd of suggested clipIf it looks good you can test the resistance off the coil. So you can put your meter to ohms. CheckMoreIf it looks good you can test the resistance off the coil. So you can put your meter to ohms. Check our leads. And we're going to measure between the end and the edge of the coil.
How long do UV ballast last?
UV lamps should be replaced once every 12 months. UV lamps have a lifespan of approximately 9,000 hours. Calculated out, this means the lamp can operate for about 375 days before requiring a replacement.
How do you tell if UV clarifier is working?
0:561:50How to check if your UV light is on - YouTubeYouTubeStart of suggested clipEnd of suggested clipIt's too hard to see the globe. Whereas. If you go and look at at at nighttime you should definitelyMoreIt's too hard to see the globe. Whereas. If you go and look at at at nighttime you should definitely see the light blue glow which means the tube is in and the tube is actually working.
Why is my UV sterilizer not working?
If it is not working the lamp is bad, the ballast is bad, or there is an electrical problem. Each ultraviolet sterilizer has a rating for the pond size it will handle and the maximum flow rate it can handle.
Do UV lights lose their strength?
Like your average light bulb, UV lights have a finite life span that requires them to be changed on a regular basis. As these lights operate, they slowly lose their effectiveness as a germicidal agent by about 15 percent each year.
How do you test a UV bulb with a multimeter?
1:042:04Using a Multimeter to check a light bulb - YouTubeYouTubeStart of suggested clipEnd of suggested clipOkay you take one lead put it on the side of your light bulb tap it to the center. See this voltMoreOkay you take one lead put it on the side of your light bulb tap it to the center. See this volt this light bulb has 17.5 old filament inside it saying this is a good light bulb.
How can I test my UV light at home?
A white sock or a piece of paper would suffice. Watch the item. If it turns a violet shade, the UV light bulb is functioning. If it remains primarily white, the UV light bulb might be defective.
Can I see UV light test?
UV light is electromagnetic radiation, light just beyond the visible spectrum. That's a very important point. Because it's outside the visible light spectrum, UV light is invisible to the naked eye. You can't see it!
Why is my nail lamp flashing?
There may be two causes for a blinking LED; an incorrect dimmer or an incorrect transformer. If you use an incorrect transformer, this may lead to a blinking or buzzing LED lamp, or one that fails to switch on. If you use an electronic transformer, you need to make sure that the minimal power is used.
How do you fix UV light?
0:051:25Quick Fix: UV Lights not turning on - YouTubeYouTubeStart of suggested clipEnd of suggested clipSo using some retaining ring pliers. Put them in the dimples. And turn it and just tighten it up.MoreSo using some retaining ring pliers. Put them in the dimples. And turn it and just tighten it up. And this will almost always do the trick.
Can I use a fluorescent ballast for a UV light?
Ultraviolet Ballasts. In many cases, a fluorescent ballast can run a range of UVC light bulbs. In most cases, the germicidal bulbs the fluorescent ballast is compatible with will not be on the spec sheet.
How long does it take to return a Prolamp?
Items ordered from ProLampSales can be returned within 30 days of receipt of the shipment in most cases. Please check that all of your items are present and in working condition within this timeframe.
What is Atlantic Ultraviolet?
Atlantic Ultraviolet was founded in 1963, manufacturing germicidal ultraviolet fixtures and equipment. Their products utilize germicidal UV lamps to destroy bacteria, mold, and viruses in the air and on surfaces. Atlantic Ultraviolet produces their own line of UV lamps, and continue to provide industry leadership in applied UV technology with increased research and development.
Is Larson UVC light returnable?
Larson Electronics UVC lighting products of any kind are non-returnable. If you need help with a product, please contact us before ordering or verify that you are ordering the correct item.